Commander Pulse Especificaciones descargar pdf (Pagina 25)

- 24 -

5.3.2 “Control mode selection”

When using Position control mode (pulse input)

Change the “control mode” from “Position control mode (pulse input)” to “Positioning (Point table)”.

① From the “Basic settings” tab and “Parameter Setting” window from the drop down selection “Control

mode selection” select “Positioning (Point table)



When using Position control mode (pulse input)

② Parameter PA01 will change to 000 under the “Basic settings (list)” tab.



Positioning mode (point table)

② Parameter PA01 will change to 006 under the “Basic settings (list)” tab.

③ Click “Write All”.

④ Click “OK”.

⑤ Click “OK” (Parameters will be enabled after cycling the power OFF→ON).

①

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 74 75

Sin comentarios

Commander Pulse Especificaciones Pagina 25